![]() ![]() ? When routing same to more than 8 DMC-4KZ-HDO outputs in DM-MD16x16/32x32-CPU3(-RPS), sporadically some outputs don't have freeze-frame switching. ? Vertical bezel compensation value set from the DM Tool doesn't persist across reboot for DM-RMC-4KZ-SCALER-C, instead set the value programmatically when desired. ? DM-MD8x8/16x16/32x32-CPU3(-RPS) doesn't support connecting LAN port and Content LAN port to the same subnet. The route should be re-established after the endpoint is online ? DM-TX-200-C-2G HID routing may not survive a switcher reboot. ![]() ? DM-MD8x8/16x16/32x32-CPU3(-RPS) doesn't support connecting LAN port and Content LAN port to the same subnet Wall configuration can be recovered by resending the configuration values from Crestron SIMPL/C# program after chassis has been restarted. ? Video wall configuration on DMC-4KZ-HDO cards may be lost after a power cycle or switcher reboot. ? It is recommended to uninstall previous versions of XPanel from Desktop before installing it from DMPS or installation may fail. ? Adobe Air version 32 or later must be installed prior to XPanel installation. ? After a reboot or power cycle, XPanel may become stuck on a "system is loading" screen. ? With safe cascade turned off, cascaded blade information does not show up after a hot plug of the fiber/cable between the two switchers. See OLH Answer ID 1000914 for more details. ✔ ️ Fixed issue with some cascaded system configurations that resulted in disabled ethernet ports being enabled during startup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |